SGU Smart General Data Collection Unit

s2ndoboz

Our general data acquisition unit is suitable for any standard sensor, the collection and transmission of its measurement data wirelessly. It has up to 8 configurable sensor inputs, plus one RTU Modbus input, transmitting the collected data to the end user via LoRaWAN or NBIoT network.

With its own battery without an external power source, it works for up to 4-5 years wirelessly. Supplied with IP68 protection on request. It allows the design of a well-scalable system that can be tailored to the customer’s needs.

Personalized visualization, automatically generated reports, notifications and alert thresholds, Analytics supported by Business / Artificial Intelligence – all serve to provide the customer with the highest possible level of service and to operate safely and efficiently.

SGM Modbus RTU Protocol Reading

Our SGM Modbus RTU data collecting unit possesses one Modbus RTU input. It transmits the collected data to the end user via LoRaWAN or NBIoT network.

With its own battery without an external power source, it works for up to 4-5 years wirelessly. Supplied with IP68 protection on request. It allows the design of a well-scalable system that can be tailored to the customer’s needs.

Personalized visualization, automatically generated reports, notifications and alert thresholds, Analytics supported by Business / Artificial Intelligence – all serve to provide the customer with the highest possible level of service and to operate safely and efficiently

modbus-lora

SWP Predictive Sewage Shaft Maintenance

It is the responsibility of the operator to regularly inspect and maintain the sewage pumps and pumps at the prescribed intervals. In the event of an emergency or when the pump needs to be repaired, a shutdown will result. A significant number of failures can be avoided by using our solution.

The Sensors2Net system continuously measures and transmits the operating time, current consumption, pressure values and the amount of water delivered to the server. It can be installed and used not only for new equipment, but also for existing, operational lifts. No old sensors need to be replaced in most cases! By processing the data transmitted by the system via a wireless connection, the maintenance processes can be optimized, the previous preventive maintenance can be replaced by the so-called predictive, predictive maintenance. Maintenance tasks can be performed more efficiently, the number of failures is reduced, and operational safety is increased. It is possible to coordinate the operation of lifts operating far apart.

Measured parameters:
  • pump operating time and current consumption
  • pressure values
  • wastewater levels
  • operating status feedback
Result:
  • monitoring operation and device status
  • calculated values
  • alarms based on trend calculation
  • coordination of the operation of lifts
  • optimized, predictive maintenance and troubleshooting prevention